16 - large washers to attach rotisserie
to vehicle
Building the Cross Member
1. Mount the engine stand arms to the
914 body.
2. Cut and fold the cross member so
it will conform to either the front or rear panel.
(The rear panel needs less of a fold.)
3. Fit the cross member and attaching
arm together and weld.
4. Center and weld the engine stand
hub.
5. Weld all areas possible.
6. Repeat step for remaining panel.
Cross member
front 57 inches A - 18”
B - 20”
C -18"
Cross member rear
50 inches
A - 15”
B - 18.5”
C - 15”
Cut out rear cross member to
clear tow eye D.
Building the Stand - (Refer to the diagram)
1. Cut the yolk from the engine stand.
2. Cut and weld the pieces as shown
in the picture.
3. These are 2 separate pieces welded
together.
4. Weld the yolk and attach the casters.
5. Additionally - Drill a 1/2”
hole in each stand to connect it to the other wing
with a 1-3/4” X 10’ box tubing.
WARNING: Do not move or touch the vehicle
while it is on stand without first connecting the stands
to each other. Be sure that the tubing goes at least 6”
into each stand and is bolted securely. If you fail to
do this, the stand could fold under the vehicle damaging
you and the panel involved.
