PORSCHE 914 ABS SENSOR
Can't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: ALL - Fuel/Exhaust (includes uncategorized and accessory items)
90 degree adapter for hard to reach places.
Having problems with your check engine light?
Want to run cat bypass pipes or a free flowing sports catalyst set up on your vehicle without having to reprogram the dme (ecu)?
Our adapter offsets the oxygen sensor about 1.5 inch from the gas stream. This achieves, in most cases, a sufficient measurement for the air/co ratio and increases the tolerance range between the pre and post cat oxygen sensors. In addition, the sensitivity of the oxygen sensor is also reduced allowing you to run a nearly any exhaust or catalytic set up, including bypass pipes, without the need to reprogram your ecu!
Use only for the 2nd oxygen sensor (after catalytic)!
This ite...(choose a part on the right to read more)
General Fitment ALL
features:
• factory fit and quality worthy of your Porsche 928!
• direct replacement for all 928 factory cat sections (note: 928s with factory/aftermarket dual exhaust systems only)
• unique modular design that enables you to easily switch from cats to no cats in approx 30 minutes with normal hand tools.
• mandrill bent 1-piece head pipes for maximum flow without turbulence created from welding multiple sections together
• 2.5" high flow design
• 304 stainless steel construction
• cat version is 10 lbs lighter than stock factory cats and no cat version is 14 lbs lighter!
• custom made crossover section from preformed 304 stainless steel which guarantees repeatabl...(choose a part on the right to read more)
features:
• factory fit and quality worthy of your Porsche 928!
• direct replacement for all 928 factory cat sections (note: 928s with factory/aftermarket dual exhaust systems only)
• unique modular design that enables you to easily switch from cats to no cats in approx 30 minutes with normal hand tools.
• mandrill bent 1-piece head pipes for maximum flow without turbulence created from welding multiple sections together
• 2.5" high flow design
• 304 stainless steel construction
• cat version is 10 lbs lighter than stock factory cats and no cat version is 14 lbs lighter!
• custom made crossover section from preformed 304 stainless steel which guarantees repeatabl...(choose a part on the right to read more)
This tire pressure sensor is made by the original manufacturer to Porsche, huf. It is a good idea to change the valve stem out when changing the sensor. The valve stem is part # 993343018001 huf and major organizations including the tire industry association, recommend the tpms sensor and valve be replaced for: fitting new tires puncture repairs changing rims electronic failure damage during tire service damage by road hazards valve core or nut seizure did you know that the transportation recall enhancement, accountability and documentation) act in the u.s. Requires that 100% of all passenger cars, light trucks, and buses manufactured in the united states after september 2007 be equipped with a tire pressure mo...(choose a part on the right to read more)
$1,432.32
Make a selection
$1,094.64
Make a selection
$1,074.64
Make a selection
© 2024 Automobile Atlanta Inc.
505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844
|