4 not categorized PORSCHE BOXSTER TIGHT ENDCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 914 1970-76 (includes uncategorized and accessory items)
99334703104 If your outer tie rods are worn, you will experience sloppy steering response and knocking / creaking sounds. Your outer tie rods keep the steering centered, so failure can be dangerous and can seriously affect steering control. After replacing the tie rods, you will experience tighter, more precise feedback without noise. Tie rod consists of: 1 qty. Tie rod 1 qty. Hexagon nut (m14 x 1.5) 1 qty. Inner axial joint 1 qty. Lock nut 1 qty. Dust bellows / boot we recommend replacing the right and left side tie rods at the same time. Sold individually. 2 necessary per car.
$233.59
Make a selection 411261813 Great news! the original j pipe cap that the factory used to cap off the passenger j pipe when they in 1973 installed the updated blower motor is finally available via your friends at Automobile Atlanta. Never offered as a separate part by the factory, this cap installs over the pipe and clamps off with a stainless clamp allowing for single blower outlet fans to function properly via the short heater blower hose while providing a tight seal to the heater system. Necessary concours entry equipment, no properly restored 73-74 014 can be without it. General Fitment914 1970-76
$21.06
Make a selection 90110517200 Large nut at the end of the camshaft to secure the gear. tightened with the special Porsche tool. two required. View/Change Diagram
From $71.18
Make a selection 99334703181 If your tie rod is worn, you will experience sloppy steering response and knocking / creaking sounds. Your tie rod keeps the steering centered, so failure can be dangerous and can seriously affect steering control. After replacing the tie rods, you will experience tighter, more precise feedback without noise. Tie rod consists of: 1 qty. Tie rod 1 qty. Hexagon nut (m14 x 1.5) 1 qty. Inner axial joint 1 qty. Lock nut we recommend replacing the right and left side tie rods at the same time. We also recommend replacing the bellows, part # pcg419831c sold individually. 2 necessary per car.
From $327.24
Make a selection P2 The most obvious advantages with safety devices is the tight fitment to the interior and proper mounting points. The mounting points are typically to the longitudinals or boxed members, which gives you extra chassis stiffening (when using a full 6 point cage) by greatly reducing the longitudinal twisting of the chassis and also allows the fitment to be as tight to the interior as possible, therefore giving you the least intrusive cage on the market. Made from cold drawn seamless tubing (cds), safety devices six point competition cages are the finest in the world, made to the most exacting standards. Structures provide maximum compressive strength with the minimum possible bends so avoiding the weaknesses in sha...(choose a part on the right to read more) General Fitment914 1970-76
$1,398.60
Make a selection FVD10397599 Cp-carrillo's fastener assembly lube is molybdenum based lubrication grease with enhanced properties. This product offers an improved clamp load repeatability, greater resistance to high pressure and temperature (range -22f to 1200f), and no oil contamination. The coefficient of friction stays unchanged, even after several connecting rod bolt re-tightening and loosening processes. We highly recommend lubricating the connecting rod bolt head and thread with this lubricant. Be sure to add it to your order if you are replacing your rod bolts. Sold individually.
$17.82
Make a selection FVD3629650061 For a uniform appearance we recommend replacing all 40 nuts. There are 10 per wheel for a total of 40. Sold individually. Please note: tightening torque is 22-23 nm.
$5.94
Make a selection
© 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |