![](https://30ed524141d0cac60ab4-d2e2d18a14257de3b9ce428cf077ee97.ssl.cf2.rackcdn.com/acban.jpg)
Vehicles
Sections
441 not categorized PORSCHE 964 KCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 TURBO/GT2 2001-05 (includes uncategorized and accessory items) ![]() FVD205964002HA
$421.58
Make a selection FVD205964001VA
$496.65
Make a selection FVD641605015
$86.63
Make a selection FVD20703500 This oil cooler kit is a must for engines that are modified. It reduces oil temperature and protects the engine. This kit can lower operating oil temperature up to 60* f. Simple installation without cutting or modifying. High quality behr cooler ensures reliability without sacrificing a/c performance as kit is mounted clear of the front a/c condenser. Can be mounted on cars with or without air conditioning. Sold as a complete kit, ready for installation.
$3,130.83
Make a selection FVD33396401 A cost-effective combination of bilstein b6 shocks with a set of German h&r lowering springs. This kit is a perfect balance of performance and comfort for street use. Benefits: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Slightly lower stance at 1.3 inches (35 mm) front / 1.18 inches (30 mm) rear. Marked improvement in safety and sportiness. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Please note: if you would like to reduce the ride height, please order part # 115110016 which will lower the stance by another 1.5 inches (40mm).
$2,665.62
Make a selection FVD33150030 This kit is complete and includes a total of 8, 4 smaller and 4 larger for the rear control arms. Our weather sealed monoball cartridges are crafted in high carbon steel and 7075 t6 aircraft aluminum. They will positively locate the suspension arms so suspension motion is accurately repeated in every corner. Sold as a set of 8. 1 kit is necessary per car. Please note: noise may resonate inside the cabin during street use.
$784.25
Make a selection FVD333505007
$53.22
Make a selection FVD33396410 A cost effective FVD exclusive combination of bilstein clubsport shocks with a set of eibach pro kit springs. This suspension kit is meant for those who want the car to sit at the lowest possible ride height. This set up will allow you to lower the front axle by 2.4 inches (60 mm). This is a perfect kit for clubsport or race use where the surfaces are smooth and even. The stock rs ride height was 1.6 inches (40 mm) lower. So, this is a full 3/4 of an inch (20 mm) lower on the front axle. Sold as a complete kit. 1 kit is necessary per car. Please note: we recommend the b6 / ohlins suspension kits for those looking for more comfort for street use.
$2,862.83
Make a selection FVD341999R Replace worn-out original soft rubber (65 shore hardness value) control arm bushings with our FVD clubsport series. They are made from rubber with a 85 shore hardness value which is the same as the rennsport models. 85 shore is more durable, provides more positive suspension location and is quiet and more forgiving than a monoball upgrade. This is the ideal upgrade for street and light track / clubsport use. This bushing set is made in Germany, weather sealed, crafted in high carbon steel and 7075 t6 aircraft aluminum and includes 85 shore hardness value cores. This is a front and rear bushing for the front lower control arm (wishbone). 2 sets are necessary per car.
$130.52
Make a selection FVD347930SW1 This kit includes everything needed to recover your original 4 spoke steering wheel from the factory. The kit includes precut leather, needle and stitching thread. Sold individually. Please note: other colors are available on request. Please contact us for further details.
$249.48
Make a selection FVD37505504
$103.95
Make a selection FVD3522945964R
$3,943.17
Make a selection FVD37505502
$100.49
Make a selection FVD424964005NS
$321.09
Make a selection FVD50501900 When you are installing a lightweight bumper or bumper bar for racing use, you want to remove as much weight as possible. Don't forget to remove your heavy factory supports. These are a lightweight alternative and are made in Germany. Weighs: .3 kilograms ( .33 lbs ) sold individually. 2 needed for the rear or front bumper. Measurements shown are in centimeters. Please note: these fit the 928 87-91 front bumper, 964 / 965 89-94 front bumper, 993 94-98 rear bumper. Please check the model fitment tab to ensure accurate fitment. General Fitment911 GT3 2003-05911 TURBO/GT2 2001-05 911 1998-05
From $149.00
Make a selection 99919234350EQ Belts undergo a lot of friction and wear. They are cost effective to change and will keep your alternator and engine in good condition. Be sure to follow recommended service and replacement intervals set by Porsche on belts. For 964 c2 tip trans. / 993 tip trans. / 993 c2/ s manual trans. And the 993 turbo. Sold individually. 1 necessary per car.
$11.55
Make a selection FVD55246600 High quality polished carbon dash trim piece. Great detail is taken to attempt to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. This cover is a carbon replacement for original # 964 552 466 00 01c. Sold individually.
$139.76
Make a selection FVD5550011RSKEV Great detail is taken to attempt to match the original weave size, color and polish. Whether you are adding carbon to the interior or matching existing pieces, this is high quality and is made in Germany so it is made to last, like the original. Sold as a set.
$845.72
Make a selection FVD60296400 This is the toothed belt inside the distributor that keeps the rotors in time. With age they become worn and brittle, eventually they will break leaving half of your motor without spark. Sold individually.
$28.88
Make a selection FVD641102101WTR01 Like new
$66.99
Make a selection FVD6314051 Now we can offer you OEM quality clear turn signals. We have sourced these from Bosch in Germany directly. Bosch is a worldwide leading developer and manufacturer of automotive technology. They represent maximum quality and reliability and go above and beyond any minimum legal specifications. These turn signals are e-1 certified in Germany. They will not fade and discolor with time like those on the market in the past. The set includes 2, 12v 21 watt amber bulbs to meet road regulations. If you would like a clear set of bulbs that flash amber, order part # FVD631752 sold as a set. 1 necessary per car. Please note: these are euro spec turn signals so the flat reflectors hole for the bulb holder is not cutout. Eu...(choose a part on the right to read more)
$340.73
Make a selection FVD641102101W3R01 Like new
$66.17
Make a selection FVD63191101
$1,149.23
Make a selection FVD641102M101TWR01 Like new
$66.99
Make a selection FVD641102105SUNR01 Check-engine light down left. Like new
$66.99
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |