398 not categorized PORSCHE 993 REAR LEDCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 2005-08 - Front Axle/Steering (includes uncategorized and accessory items) 150TBF900 Replace worn-out original front control arm / wishbone bushings with this longer lasting poly-graphite plastic bushing. Poly-graphite is higher density than OEM rubber so suspension components will experience less deflection. It is specially formulated with a graphite lubricant to produce a bearing like action. This is located at the front of the control arm / wishbone. The correct matching poly-graphite bushing for the rear of the control arm is part # 150tbr900 sold individually. 2 necessary per car.
$48.40
Make a selection 19271419 The kw hls (hydraulic lift system) provides additional road clearance for lowered vehicles. When expanded, a range of 30mm to 45mm of lift is produced, thereby helping sport cars avoid road clearance difficulties like speed bumps, road constructions etc. General Fitment911 2005-08
$9,516.14
Make a selection FVD803993VR0222 High quality, German made three-point replacement safety belt, designed to perform like the original. Features / specs: belt length: 300 cm (118 inches) 3 point inertia reel belt angle adjustable reel (max. Of 8 *) includes 22 cm (8.5 inch) buckle, installation hardware and caps. Din-en-iso 9001: 2000 quality standard manufactured, e-mark approved. The matching rear belt is part # FVD803993hr sold individually. 2 necessary per car.
$187.00
Make a selection FVD98661810MG Genuine: engine - 6 cylinder boxer capacity - 2480ccm compression ratio - 11,0:1 max. Power - 150kw (204hp) @ 6000rpm max. Torque - 245nm (181lbf ft) @ 4500rpm max. Speed - 240km/h max. Rpm - 6700rpm acceleration 0-100km/h - 6.9s tuning: max. Power - 158kw (215hp) @ 6000rpm max. Torque - 260nm (192lbf ft) @ 4500rpm max. Speed - 247km/h max. Rpm - 6900rpm acceleration 0-100km/h - 6.7s very important note: our tool can only flash ecu's with the Bosch # 0 261 204 605. If your ecu does not have this Bosch # then the ecu must be sent to us to be flashed in house. Please check the sticker on the outside of your ecu to determine which Bosch # you have. You can check by opening the rear trunk and pulling the carpet li...(choose a part on the right to read more)
$984.50
Make a selection FVD631404 Don't let cracked or faded lenses detract from your cars appearance. Replace them with these high-quality OEM replacements, designed to perform like the originals. The red lenses were genuine equipment on usa models, but they really clean up the rear when added in place of the amber look. Quality replacement part manufactured by dansk. They offer a complete line of replacement parts to complement the entire Porsche model range. All dansk products are manufactured to the highest of European standards to ensure the quality and performance you expect for your Porsche. This commitment has made dansk one of the original equipment suppliers to the Porsche in Germany. Sold as a set. 1 necessary per car.
$119.90
Make a selection 150PB1027 Replace worn-out original sway bar bushings with this longer lasting poly-graphite plastic bushing. Poly-graphite is higher density than OEM rubber so suspension components will experience less deflection. It is specially formulated with a graphite lubricant to produce a bearing like action. We also recommend replacing the sway bar to ball pin bushing at the same time to save on labor costs, part # 90134378200 sold individually. 4 necessary per car. Please note: this fit's 911 models from 1978-89 if fitted with an 18mm original rear sway bar.
$49.50
Make a selection 35271419 Kw variant 3 coilover kit with front & rear hls 4 lift system Porsche 997 c4 05+ General Fitment911 2005-08
$13,201.64
Make a selection 35271415 Kw variant 3 coilover kit with front & rear hls 4 lift system Porsche 997 c2 05+ General Fitment911 2005-08
$12,143.24
Make a selection 5007206905 This is a perfect gift or great to have for your collection! It is colorful red, white & blue, very detailed because you can see on one side the front of a racing Porsche 911 GT3 rs and on the other side the rear of the car. It is also very unique because of the picture from a Porsche inside the cup.
$28.00
Make a selection 150PB100918 Replace worn-out original sway bar bushings with this longer lasting poly-graphite plastic bushing. Poly-graphite is higher density than OEM rubber, so suspension components will experience less deflection. It is specially formulated with a graphite lubricant to produce a bearing like action. We also recommend replacing the sway bar to ball pin bushing at the same time to save on labor costs, part # 90134378200 sold individually. 4 necessary per car. Please note: this fit's genuine rear sway bars only.
$44.00
Make a selection 11599702 Non pasm cars - lowers the front 1.0 inch (25 mm) and the rear 1.0 inch (25 mm). Pasm cars - lowers the front .8 inches (20 mm) and the rear .8 inches (20 mm). Targa - lowers the front 1.3 inches (35 mm) and the rear 1.3 inches (35 mm).
$470.80
Make a selection 115900993B12 If you're looking for the perfect combination of sporty dynamics, a superior appearance and high performance, you're on exactly the right track with this sport suspension. This kit is a direct replacement for the factory mo33 kit and will give you the same performance characteristics. -professional cornering system pcs -precise response, excellent driving performance and high reserves of safety -lowering up to 10 - 15 mm in front and rear -eibach pro-kit performance springs with progressive characteristic -springs and shock absorbers road-tested and fine-tuned to complement one other perfectly -bilstein gas pressure technology -bilstein mono-tube/upside-down technology, made in Germany -German TUV certificate...(choose a part on the right to read more)
$2,258.33
Make a selection 115993S1 Lowers the ride height by 30 mm (1.2 inches) in the front and 30 mm ( 1.2 inches) in the rear.
$663.30
Make a selection 90151107321 This is the rear release cable for the rear engine deck lid. It is 1900 mm in length. When replacing this cable, we also recommend replacing the handle, part # 90155281320 and the grommet, part # 91151253100. Also, check your rear lid lower lock, part # 90151205200, perfect time to replace it if it is corroded and the spring is worn. Sold individually. 1 necessary per car.
From $9.50
Make a selection 90133300309B This rear spring plate is manufactured to the highest of European standards to ensure the quality and performance you expect for your Porsche. New OEM spec. (65 shore) rubber bushings are installed to make this a direct bolt on. Features: made from ¼ inch spring steel includes new OEM spec. (65 shore) rubber bushings made in Germany sold individually. Left or right-side fitment. 2 necessary per car.
$306.90
Make a selection 91150411302EQ This one-piece seal is furthest from the rear bumper, we recommend replacing this when removing the motor for maintenance. We recommend replacing both the small and large engine seals, the large is part # 91150411102 sold individually. 1 necessary per car.
$16.50
Make a selection 911561053003EQ Rear window cabrio top section, manufactured in Germany with original sonnenland material. It is as close to the original as possible and is cut and trimmed to fit perfectly. Sonnenland material consists of 3 layers, dyed acrylic twill weave top layer, elastomeric rubber inner layer and polyester woven base layer. It provides increased strength against abrasion, increased fade resistance and the tighter woven layers for the mechanically operated tops. Sonnenland high quality material was originally used by Porsche and other top German manufacturers. Made in Germany. Sold individually. 1 necessary per car.
$984.50
Make a selection AP997TTKIT In the quest to create the most well balanced suspension for the 997 turbo, agency power has developed these sway bars to our specifications. The all wheel drive Porsche turbo cars naturally have a lot of under steer. Under steer is when you take a turn but your car keeps going outwards. With an awd car, getting the rear end around can be easily done with a larger sway bar. However you do not want to induce to much over steer as then you will be throttle steering or sent into a drift. With the combination of a properly balanced front and rear sway bar, your car will handle turns much more neutrally and quickly. The sway bars are designed to stiffen up the chassis as well to reduce body roll. Some times called â...(choose a part on the right to read more) General Fitment911 2005-08
$569.91
Make a selection 91150306203EQRB Without door post without rear lamp holder but: what you need for most quarter panel body repairs!
$1,654.40
Make a selection 96454303502 Necessary when replacing your right rear quarter window, as this seal retains the window in the body and prevents moisture from getting in. For 964 coupe models. Sold individually. 1 needed per car. Driver's side fitment.
From $90.50
Make a selection 93035204501EQ The zimmermann OEM brake disc combines high-quality cast materials, a vented and perforated braking surface and includes z-coating. Features: better wet braking performance by permanent expulsion of brake dust and water. Sporty look. Anti corrosion "z-coating" prevents rust. Noticeable improvement in braking performance. Countersunk holes double as wear indicator. Simple bolt on, modifications are not necessary. Made in Germany. Sold individually. 1 necessary per car. Rotors should always be changed in pairs; the rear right is part # 93035204601eq
$237.60
Make a selection 93035204601EQ The zimmermann OEM brake disc combines high-quality cast materials, a vented and perforated braking surface and includes z-coating. Features: better wet braking performance by permanent expulsion of brake dust and water. Sporty look. Anti corrosion "z-coating" prevents rust. Noticeable improvement in braking performance. Countersunk holes double as wear indicator. Simple bolt on, modifications are not necessary. Made in Germany. Sold individually. 1 necessary per car. Rotors should always be changed in pairs; the rear left is part # 93035204501eq
$237.60
Make a selection 96410601402EQ This OEM cover sits low nearest the rear bumper. If you are removing the motor for maintenance, be sure to check and replace the engine covers / heat shields as necessary. We recommend purchasing a new seal, part # 96410622301 and plug, part # 96410623701 to complete the installation. Sold individually. 1 necessary per car.
$601.70
Make a selection 964561005016HA This is a complete cabrio top made in Germany with original sonnenland material. It is as close to the original as possible and is cut and trimmed to fit perfectly. Includes a trapezoidal pvc plastic rear window with a zipper like the original. If the window gets hazy simply unzip, remove and add a new window. Sonnenland material consists of 3 layers, dyed acrylic twill weave top layer, elastomeric rubber inner layer and polyester woven base layer. It provides increased strength against abrasion, increased fade resistance and the tighter woven layers are made for modern electric tops with stronger frames, like the 911 and 964. Sonnenland high quality material was originally used by Porsche and other top German ...(choose a part on the right to read more)
$2,201.10
Make a selection 96454303602 Necessary when replacing your right rear quarter window, as this seal retains the window in the body and prevents moisture from getting in. For 964 coupe models. Sold individually. 1 needed per car. Passenger's side fitment.
From $89.00
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |