![](https://30ed524141d0cac60ab4-d2e2d18a14257de3b9ce428cf077ee97.ssl.cf2.rackcdn.com/acban.jpg)
PORSCHE 356 A LED KITCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1987-89 - Transmission (includes uncategorized and accessory items) ![]() FVD331993001 Our new rear sub frames contain rubber inserts with a shore hardness value of 85, like what is used on rennsport models. It offers rs style handling characteristics, superior durability and is still forgiving enough for street use. FVD clubsport sub frame facts: - better handling. - makes precision adjustments of the suspension easier. - does not produce road noise. - shore hardness value of 85. - direct OEM replacement. - more forgiving for street use. - new sub frames with inserts installed. Sold as a set. 1 kit is necessary per car.
$1,758.90
Make a selection FVD33150003 Rear toe control arms - order in pairs only restore proper suspension geometry with this adjustable lower rear control arm. The factory control arm can't compensate enough when lowering your Porsche, leaving you stuck with as much as ½ of toe in. The result is poor handling and rapid tire wear. This kit will provide the additional adjustment needed. The adjusting link has a left and right hand thread on each end. Rotating the link will increase or decrease the overall length of the arm. A precision teflon lined spherical rod end replaces the compliant rubber factory bushing for improved suspension response and feedback, and also reduces toe changes during acceleration and deceleration.
$218.90
Make a selection FVD33150010 Our weather sealed monoball cartridges are crafted in high carbon steel and 7075 t6 aircraft aluminum. They will positively locate the suspension arms so suspension motion is accurately repeated in every corner. Sold as a set. 1 kit is necessary per car. Please note: we recommend this kit for race use, as noise may resonate inside the cabin during street use. For those that are concerned about the noise, please order part # FVD3310212291
$704.00
Make a selection FVD33396410 A cost effective FVD exclusive combination of bilstein clubsport shocks with a set of eibach pro kit springs. This suspension kit is meant for those who want the car to sit at the lowest possible ride height. This set up will allow you to lower the front axle by 2.4 inches (60 mm). This is a perfect kit for clubsport or race use where the surfaces are smooth and even. The stock rs ride height was 1.6 inches (40 mm) lower. So, this is a full 3/4 of an inch (20 mm) lower on the front axle. Sold as a complete kit. 1 kit is necessary per car. Please note: we recommend the b6 / ohlins suspension kits for those looking for more comfort for street use.
$2,726.53
Make a selection 99310090236EQ FVD cylinder head gasket sets contain high quality German sourced gaskets, seals and o-rings. This kit contains a complete set of gaskets to make a teardown / rebuild more convenient. Sold as a complete set. 1 necessary per car. To complete the gasket set for the whole engine also order part # 93010090104eq
$614.58
Make a selection FVD33396401 A cost-effective combination of bilstein b6 shocks with a set of German h&r lowering springs. This kit is a perfect balance of performance and comfort for street use. Benefits: optimum adhesion and enhanced stability for daily driving and extreme driving situations. Slightly lower stance at 1.3 inches (35 mm) front / 1.18 inches (30 mm) rear. Marked improvement in safety and sportiness. Bilstein gas pressure technology. Bilstein mono-tube/upside-down technology. Made in Germany. Please note: if you would like to reduce the ride height, please order part # 115110016 which will lower the stance by another 1.5 inches (40mm).
$2,538.53
Make a selection 93020705304 Pmo parts is proud to introduce a euro style oil cooler to replace “trombone” style coolers used in most g-model cars.
From $459.00
Make a selection BBI9974010001 Features
$1,895.00
Make a selection 99711608690 Includes bushings. Oem specifications. We recommend our part # FVD116999 which includes this clutch fork and everything needed for installation. Not sure which clutch parts are right for your car? We have pre-packaged kits that include everything that you need for installation. Check them out under the clutch kits category. View/Change Diagram
From $143.58
Make a selection BBI9911070001 The bbi autosport intercooler kit is a direct replacement upgrade for the Porsche 991 turbo. Designed with 3d modeling & computational fluid dynamics software, this bespoke intercooler features 3d printed and cfd tested end tanks, and offset cores for optimum flow and improved performance. The advanced 3d printing manufacturing process allows complex design and shapes to be produced for optimum flow. This kit is ready for installation (plug & play), using the stock plumbing and shrouds. When engineering, technology, and the right people are fueled by passion, the results are impressive.
$4,395.00
Make a selection F6464120010 Instrument faces are one of the most visible and frequently looked at components in your Porsche. When making the decision to change them you want to make ensure that you select a high quality product similar to your originals. Each of our sets are made in Germany and use the factory scripting (font). Our faces also offer the same uniform night time shading and includes the original die cut notches for easy installation. Each kit is made for global distribution, so simply pick out the faces that match your originals. They are available in a variety of colors to make a bold statement, or to match exterior paint schemes. This kit includes faces for: manual transmission / tiptronic transmission / kph / mph / celsi...(choose a part on the right to read more)
$603.90
Make a selection F9164120103 Instrument faces are one of the most visible and frequently looked at components in your Porsche. When making the decision to change them you want to ensure that you select a high-quality product like your originals. Each of our sets are made in Germany and use the factory scripting (font). Our faces also offer the same uniform night time shading and include the original die cut notches for easy installation. Each kit varies, so simply pick out the faces that match your originals. They are available in a variety of colors to make a bold statement, or to match exterior paint schemes. Don't see the color or combination that is right for your car? Or perhaps you want a custom logo in the tach? Kindly contact us f...(choose a part on the right to read more)
$843.70
Make a selection FVD10603500 Protect your engine and lower the operating water temperature by up to 60* f. Our kit contains everything you need to install this kit on a 3.4l 996. Don't be fooled by cheaper kits that claim they are complete, if the radiator is not supported correctly, road and track vibrations can destroy your investment. This fits Carrera c2 and c4 with manual transmission only ! This will not fit cars equipped with a tiptronic transmission.
$1,109.80
Make a selection 99660610599 If you are noticing engine vibrations, misfires and even backfiring your crankshaft position sensor maybe bad. Your car's dme (ecu) uses the signal from the crankshaft position sensor to control ignition timing and fuel injection, so if your sensor is failing your engine is suffering from poor timing and is not running efficiently. This kit is complete and ready to install.
$132.75
Make a selection 93035104703EQ The zimmermann OEM brake disc combines high-quality cast materials, a vented and perforated braking surface and includes z-coating. Features: better wet braking performance by permanent expulsion of brake dust and water. Sporty look. Anti corrosion "z-coating" prevents rust. Noticeable improvement in braking performance. Countersunk holes double as wear indicator. Simple bolt on, modifications are not necessary. Sold individually. 1 necessary per car. Rotors should always be changed in pairs; the front right is part # 93035104803eq please note: if you are looking for a kit with pads, etc. Please check our brake service kit selection.
$237.60
Make a selection 95011691101 Clutch kit beginning to fail? Eliminate your clutches slipping and chattering with this genuine kit. Clutch kit includes: 1 qty. Clutch disc 1 qty. Pressure plate 1 qty. Release bearing 1 qty. Spline lubricant kit weighs 26.9 lbs. (12.2 kg) tech tip: due to a supersession, the guide tube 95011681306 must also be replaced. You can check this by measuring the outer diameter of your guide tube, which must be 32mm in order to install this kit. View/Change Diagram
From $765.78
Make a selection F91641202TU04S Instrument faces are one of the most visible and frequently looked at components in your Porsche. When making the decision to change them you want to make ensure that you select a high-quality product like your originals. Each of our sets are made in Germany and use the factory scripting (font). Our faces also offer the same uniform night time shading and includes the original die cut notches for easy installation. Each kit varies, so simply pick out the faces that match your originals. They are available in a variety of colors to make a bold statement, or to match exterior paint schemes. Don't see the color or combination that is right for your car? Or perhaps you want a custom logo in the tach? Kindly contac...(choose a part on the right to read more)
$1,021.90
Make a selection F91642202041 Instrument faces are one of the most visible and frequently looked at components in your Porsche. When making the decision to change them, ensure that you select a high-quality product like your originals. Each of our sets are made in Germany and use the factory scripting / font. Our faces also offer the same uniform night time shading and includes the original die cut notches for easy installation. We carry a wide variety of kits that are made for global distribution, so simply pick out the set that matches your originals. Our instrument kits are available in a variety of colors to make a bold statement, or to match exterior paint schemes. We also sell sport chrono instrument faces and compass faces, to match ...(choose a part on the right to read more)
$1,257.30
Make a selection F9164120105ME Instrument faces are one of the most visible and frequently looked at components in your Porsche. When making the decision to change them you want to ensure that you select a high-quality product like your originals. Each of our sets are made in Germany and use the factory scripting (font). Our faces also offer the same uniform night time shading and include the original die cut notches for easy installation. Each kit varies, so simply pick out the faces that match your originals. They are available in a variety of colors to make a bold statement, or to match exterior paint schemes. Don't see the color or combination that is right for your car? Or perhaps you want a custom logo in the tach? Kindly contact us f...(choose a part on the right to read more)
$858.00
Make a selection FVD33150020 This kit is complete and includes the front and rear monoball cartridges with press tools. Our weather sealed monoball cartridges are crafted in high carbon steel and 7075 t6 aircraft aluminum. They will positively locate the suspension arms so suspension motion is accurately repeated in every corner. Sold as a set of 4. 1 kit is necessary per car. Please note: noise may resonate inside the cabin during street use.
$715.00
Make a selection FVD20798700 This FVD motorsports oil pump kit is a must for 987.1 Caymans and Boxsters driven on the track. Our kit includes a second return oil pump and our FVD motorsports oil pan. The issue: the 987.1 Boxster/Cayman from 2005 to 2008 has the factory return oil pump located on the right rear side. On the left side, the return oil pump located in front. So when driven fast in right turns, the oil from the camshaft case (rear left) does not flow back quickly enough into the oil pan. When the oil pan is starved of oil, the oil pump sucks in air and over time the motor will seize. The solution: our tandem return oil pump draws oil from the camshaft housing in (rear left, 3rd cylinder) and feeds it back into the oil pan so th...(choose a part on the right to read more)
$3,274.30
Make a selection FVD211328490 Required when adding a free-flow exhaust system with the part # FVD 211 328 489x or FVD 211 328 489xx. Also required when adding dual outlet heat exchangers or dual inlet mufflers. Sold as a kit. 1 necessary per car.
$1,288.80
Make a selection FVD207053 The oil cooler suffers from exposure to road debris, the elements and corrosion with age. It is a critical engine component, that should be replaced when any leaking is detected. This kit is ready for installation with oil cooler, oil pipes, new rubber mounts, brackets and an oil drain plug. It is a high-quality OEM replacement, designed to perform like the original. We source this part in Germany to ensure quality, reliability and precise fitment. This kit is a direct replacement kit for original part # 930 207 053 00 and current part # 93020705304. Complete the installation with our complete stoneguard kits part # FVD20705301 and FVD20705302
$885.50
Make a selection FVD1109115043 This replica high butterfly mfi throttle bodies system is for those looking for ultimate engine performance as well as an authentic rsr engine appearance. This kit keeps air consistently on tap for superior drivability. When the throttle is opened, there is an instant injection of air, providing a sharp, crisp throttle response. This efficient injection frees up more power and compliments larger displacements, high lift cams and full exhaust systems. This kit is engineered, precision machined, flow tested and manufactured in Germany. It is replicated to look as close to the original as possible. Intake trumpets (velocity stacks) are available in your choice of red or black. Includes: 6 individual stacks (50 mm ...(choose a part on the right to read more)
$7,456.90
Make a selection FVD11196415GKT This installation kit is needed to install our part numbers FVD 111 964 15 or FVD 111 964 17. Sold as a set. 1 necessary per car.
$42.90
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |