This universal flywheel lock has been designed for use on all air-cooled Porsche engines (series 356, 912, 914 & all 911s through 1969) and on all air-cooled volkswagen engines (type 1,2,3 & 4). This tool is a must when changing a flywheel or its seal and it comes in handy when changing a clutch. Made from a forging, this quality tool will last a lifetime. Gpcg91101000.

Check out rst215 for an alternative flyhweel lock tool.

General Fitment

If you 914-6 and early 911 owners experience loss of power at high speeds or low speed rich running and you haven’t checked the float lever, you’ve missed an important diagnosis. Float level is critical for proper carb tuning. This custom designed tool easily accesses the float bowl and is calibrated for precise measure.

General Fitment

Trying to adjust the inner rear caliper brake pad and cannot reach the adjuster through the swing arm? We have the solution! This super long 4 mm allen wrench with built in 3/8 inch drive socket accesses both the cap and adjuster and gives plenty of clearance for your ratchet. For 356, 911, 912, 914, 924, 928, 944, 968, and Boxster.

Gearwrench 3/8" drive long ball hex bit socket - 4mm

General Fitment

The transmission filler tool is a 17 mm allen, and you cannot change the fluid without it!

General Fitment

This feeler gauge holder is needed for correct adjustment of valve clearance. Comes exclusively as shown here with its correct shape for the contour of your hand. Comes with one blade (.004").
Applicable: Porsche 356, 911, 912, 914-6, 930. Please call our office for availability.

General Fitment

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.

This schley brothers original tool has been designed to allow removal and installation of valve springs while the engine is both fully assembled and still in the car. It is professionally made of high quality materials to handle not only stock springs but the pressures of all high performance springs.

Remove rear axle nuts with this tool and your 1/2" breaker bar.

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.

Short blade stubby flat head

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.

This item may need to be sourced from Germany and would take 2-4 weeks to arrive. Once ordered it cannot be canceled. Please call to check stock or request expedited shipping.